There is quite a bit of upstream documentation, this one [PATCH v3 3/3] net: dsa: mv88e6xxx: add switchdev VLAN operations - Vivien Didelot might explain best the transition from what been and what is now
A configuration like “1t 2t 3t 4u” for VLAN 10 is achieved like this:
# bridge vlan add dev swp1 vid 10 master # bridge vlan add dev swp2 vid 10 master # bridge vlan add dev swp3 vid 10 master # bridge vlan add dev swp4 vid 10 master untagged pvidThis calls port_vlan_add() for each command. Removing the port 3 from
VLAN 10 is done with:# bridge vlan del dev swp3 vid 10
Or net: dsa: mv88e6xxx: add support for VLAN Table Unit [LWN.net]
Below is an example of what can be done with this patchset.
"VID 550: 1t 3u" "VID 1000: 2t" "VID 1200: 2t 4t"The VLAN setup above can be achieved with the following bridge commands:
bridge vlan add vid 550 dev swp1 master bridge vlan add vid 550 dev swp3 master untagged pvid bridge vlan add vid 1000 dev swp2 master bridge vlan add vid 1200 dev swp2 master bridge vlan add vid 1200 dev swp4 masterRemoving the port 1 from VLAN 550 is done with:
bridge vlan del vid 550 dev swp1
Else
https://www.kernel.org/doc/html/latest/networking/dsa/configuration.html